A 66K byte program to read, display and save the data stream from many of the 4 button LiPo chargers.
Has been tested with the Turnigy 8150, GT chargers and the Accucel 6 charger and others
The Accucel 6 and later model Turnigy 8150 chargers must have the output port added.
The Royal Electronics Omega 7 channel transmitter was produced and marketed in the early 1980's. It contained several features not found in any transmitter until the second generation of microprocesser transmitters. Features included switch servo reversing on all channels, V tail and elevrons internal mixing, end point adjustments, crossed trims, throttle trim on lower half of stick travel, CAR Coupled ailrons to rudder, plug in RF deck, etc.l. Schematics and printed circuit overlays are from one of the first protoype kits sold and built to cross check and comment on the kit & instructions. This unit was recently upgraded to 2.4 GHz using a FySky DIY transmitter rf deck.
This is the encoder schematic file size 4.99Mb
The Royal Electronics Omega 7 channel transmitter was produced and marketed in the early 1980's.
This is the battery / powersupply schematic file size 3.7Mb
The Royal Electronics Omega 7 channel transmitter was produced and marketed in the early 1980's.
This is the printed circuit board layout, double sided no plated through holes. file size 22.3Mb
Quincy Hobby Center 3632 Maine Street Quincy, IL 62305 217-223-8498 http:\\www.quincyhobby.com
